See-Through Stroker Care: ViewTube XXL LED and Vac XXL

Quick answer

Clean your ViewTube immediately after each use with warm water and mild soap, keep the LED base and pump mechanism out of the water, and dry the clear sleeve completely before storing it. The see-through material only stays see-through if you skip harsh cleaners and trapped moisture.

Step-by-step care for ViewTube XXL LED and Vac XXL

1. Separate the sleeve from the hardware: Remove the clear sleeve from the LED base or pump body before washing. Common mistake: rinsing the assembled unit and letting water seep into the electronics or suction valve. If the sleeve does not release easily, stop and check the instructions rather than pulling.
2. Rinse with warm water first: Flush the inside of the sleeve with warm water to remove lubricant and residue before any soap touches it. Common mistake: going straight to soap, which can spread a slippery film instead of lifting it.
3. Wash with mild soap and your fingers: Add a small amount of fragrance-free soap and gently work it through the sleeve, including the textured interior. Common mistake: using a brush or abrasive pad, which scratches the clear surface and causes permanent clouding. Scratches cannot be polished out of a soft sleeve, so gentle beats thorough.
4. Rinse until the water runs clear: Rinse the sleeve inside and out until no soap slick remains. Common mistake: stopping when the outside looks clean while soap residue stays trapped in the texture.
5. Shake out excess water: Shake the sleeve firmly and press it gently between a clean, lint-free towel to pull water from the surface. Common mistake: wringing or twisting the sleeve, which can tear the material at the opening.
6. Air-dry fully before storage: Stand the sleeve open in a well-ventilated spot until the inside feels completely dry, then wipe the LED base and pump body with a barely damp cloth. Common mistake: storing a sleeve that still feels cool or tacky inside, which traps moisture and encourages odor. For pump stroker drying tips, leave the suction valve open to air as well.
7. Store clear of heat and sunlight: Keep the dry sleeve in a cool, dark place, away from direct sun and heaters. Common mistake: leaving it on a windowsill, where UV and heat can yellow or warp the clear material.

Product facts

• ViewTube XXL See-Thru EZ-Grip LED Stroker: The crystal-clear sleeve is paired with an LED light show in the base. The electronics stay in the base, so wash only the sleeve and wipe the base rather than rinsing the whole unit.

  

• ViewTube Vac XXL Pump See-Thru EZ-Grip Pump Stroker: The pump model uses precision-controlled suction with a crystal-clear sleeve. Suction paths trap moisture, so the pump and sleeve need separate drying before storage.